Surface B -- The side wall was originally designed as a
2" thick wall including the 1” of machining stock.
The 2" thickness with the 1" machining stock gives
only 1" of finished thickness. This leaves the inner machine surface in the
center third of the as-cast wall.
The thickness of the wall should be
increased on the inside by 1" to 3". This keep the inner face of the
machining stock outside the center third of the wall thickness.
Copyright
2001 by the
Steel Founders' Society of America
All rights reserved.
Address comments to: blairr@sfsa.org
Last Modified:September, 2001 by STG
